Where is the obd2 socket on Renault grand scenic?
The 1.5dCi designation on a Renault Scenic stands for 1.5 litres / diesel / common rail / injection, meaning the vehicle has a 1.5 L common rail direct fuel injection diesel engine.
Boot.The Scenic offers a class-leading seat-up bootspace capacity of 572-litres, although you have to bear in mind that figure is without the removable boot floor and tyre inflation kit.The boot is well-shaped, but the load lip is a little high and with the seats folded down there's a bit of a li...
The ignition barrel can be complicated to take care of. A mechanic or someone who knows a lot about cars will be best suited to help you.
Scroll through the trip computer until you get to the "change oil soon message/miles to next service" displayed.Press and hold the mileage trip reset button on the speedo until the display flashes, and then stays fixed. This can take a few seconds.Job done!
The engine symbol is an indication that the engine needs to be checked. The water symbol indicates the colon has reached a high level. The ABS symbol refers to a braking problem.
Possibly but only very slightly. When you turn on A/C it should idle up a bit, and the vacuum will advance ever so little
There is a simple solution for this.First disconnect the battery terminals and then reconnect them this should reset all faults and errors.
remove drivers side front wheel, plastic panel behind spring/shock. real fiddly but can be done with minimal swearing ! if you have A/c then the air may be a tad bluer!
It should be found under the drivers side of the dash.
The coolant temperature sensor in a Renault Megane Scenic is located on the right hand side of the engine as you are looking at it. It is located just above the TDC sensor.
Change it as often as you can afford. The 1.4l petrol engines are notorious for throwing belts. Usually what happens is that the outer retaining shroud on the cam belt disintegrates and falls down into the belt path and becomes wrapped around the crank pulley. As a result the timing belt either b...
On some vehicles there is a special tool required. The piston is pressed and turned at the same time. Of course you must remove the master cylinder cap, in order to be able to push it back on any car. If it has a criss cross patteren on the face of the piston, then you need this tool. Some Suto P...
Lift the car, remove the tire and set it aside, remove the brake shoe/caliper and remove the brake pad. Put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car to the ground.
The service engine warning indicator, on the instrument panel, is an indication that the oil needs to be changed. Change the motor oil and the warning light should go off.
You can find the refrigerant charge port on top of the air conditioner compressor. The refrigerant charge port will be labeled as the low pressure port.
Low coolant?Heater core restricted or plugged?Heater core airbound?Water pump not circulating coolant?Heater control cable not adjusted properly?With mine it was Heater matrix clogged with radiator sealant. The workshop cleaned it and it's start working fine!
I have just sorted this problem myself on my (1996) Espace, the fuse is located under the bonnet, right hand side up in the top is a little Black box fastened to the inner wing it is a small 7.5amp fuse second row from the back...
I don't know that particular car, however most Ford/Mercury products have it on the Passenger side of the trunk, Pull the carpeting aside on the side of the trunk and you should see a black box with a red button on one side of it. Push the button until it clicks and it should be reset.
Rear passenger side! It comes out behind the rear light assembly, look for a half-inch rubber tubing inside the protecting two-inch piece of a plastic pipe that sticks from the underneath.
if you can not locate the dipstick by looking under the hood go under the vehicle and look for the oil pan right by it is usually the dipstick fallow it up and you found it. Most of the time the dipstick handle is colored yellow or black where it's located under the hood i can not tell you I have...
Below steering column to the left (Uncovered)
Its located up under the dash on the Drivers side.
The relay is separate from the actual "starter solenoid" which is found at the top of the starter (along the + battery cable).
Top 10 OBD2 Scanners (Recommended By Experts) 3) AD510 Professional OBD2 scanner from ANCEL.4) 3150e Code Reader cum Scan Tool from Innova.5) AL519 OBD2 Scanner from Autel.6) CP9580A OBD2 Scanner from Actron.7) MaxiScan MS 300 CAN from Autel.8) Innova 3100 OBD2 Scanner.9) Launch Creader vii P...
It is directly behind the radiator. To change this the radiator would have to be removed and emptied in order to change it.
The auto transmission dipstick is near the rear of the engine. Add fluid in small amounts as to not overfill.
left hand side of the car,under glove box
How do you find out the 97 Mazda protege is obd2 certified and is any obd2 tool will work on this car?
OBD2 diagnostics were federally mandated for all cars made/assembled/imported into the USA in 1996. A quick check of the emissions label on top of the radiator should tell you, as well as the shape of the diagnostic port. yes, any OBD2 tool will work.
The coil is located under the pot metal engine cover on top of engine. Remove the 4 bolts that hold this cover on , then you will see the coils located in a plastic housing under this cover.
I have a 97 Grand Am 3100 V6. The purge valve is located by the top of the charcoal canister. Simply remove the one screw from the container that holds the radiator fluid (standing over the top of the car, passenger side) and move that container to the side. The purge valve is mounted to the car ...
The powertrain computer, engine and transmission, is located inside the left front fender. You remove the tire and fender liner to access. There are also abs and front control modules under the hood. Inside the cab there are door modules, airbag, air conditioning, instrument cluster, and key/thef...
No links, only fuses. They are in the under hood and under dash fuse boxes.
The fuel pressure regulator on a 1994 Jeep Grand Cherokee is part of the pump module in the fuel tank.
Usually in a removable housing at the engine end of the upper radiator hose
Boot space.There are no worries when it comes to boot space – with the rear seats pushed all the way back, there's a reasonable 377 litres on offer.That increases to 455 litres when you push them forward – which is bigger than what you get in many cars in the class above, including the Ford Focus...
Autel MaxiScan MS300 CAN Diagnostic Scan Tool for OBDII Vehicles. BAFX Products® – Bluetooth OBD2 Scan Tool – For check engine light & diagnostics – Android ONLY. ScanTool 425801 OBDLink SX USB: OBD Adapter/Diagnostic Scanner for Windows. Autel AutoLink AL319 OBD II & CAN Scan Tool.
The oxygen sensor on a 1996 Pontiac Grand Am is found near the catalytic converter. It will be place on the piping which leads to the catalytic converter.
Assuming you have the 2.2, 4 cylinder engine, the thermostat is located on the side of the engine that faces the firewall.
The water pump is on the front center of the engine.
Origional equipment components will not have any grease fittings. Once you replace the parts with GOOD aftermarket parts you will have fittings to lube. You should get a few years out of the original parts before they need replacing
The camshaft position sensor on a 1998 Pontiac Grand Prix is located behind the rear bearing of the camshaft. It constantly monitors the rotation of the camshaft and relays this information to the computer.
At the front left corner of the fuel tank. You'll need to jack up the rear of the car to reach it.
On the gooseneck where the upper radiator hose attaches to the engine.
Sensor one is screwed into the exhaust manifold behind the engine.
under the hood, right side, color brown, 15 pins, under to another relay grey
Mounted atop the transmission tail shaft.
It is just called a 5 Point Socket or sometimes a Pentagon Socket and you can get them at online stores such as www.mytoolstore.com and Snap-On tools.It is just called a 5 Point Socket or sometimes a Pentagon Socket and you can get them at online stores such as www.mytoolstore.com and Snap-On too...
The PCV valve is located under the MAP sensor on a 1990 Pontiac Grand Prix. The MAP sensor is in the upper plenum.
For ALL engines (except VW air cooled) the oil pump is inside, in the oil pan. Remove the oil pan to find the oil pump. You'll see a pickup tube (dip tube) that goes from the oil pump into the bottom of the pan to suck oil. Follow the tube back up to the oil pump. A word of warning. If you have l...
the oil pressure switch is a 1 wire plug usually located on the engine block itself it could be on the side on the rear on the front under the motor on top
Should be in the fluid resevoir tank
Every car or truck on the road manufactured after 1996 is legally mandated to have one installed.OBD-II is an on-board computer that monitors emissions, mileage, speed, and other data about your car.It's connected to the Check Engine light, which illuminates when the computer detects a problem.
The fuel pump is located inside the gas tank.
They don't use linkage, they use a cable. The cable goes between the shift lever mechanism to the transmission.
If your looking for an inertia switch, it doesn't have one.
1 Answer.john porter, the combination Fuel Filter/Fuel Pressure Regulator is remotely mounted to the vehicle body, above the rear axle and near the front of the fuel tank (Fig.5).
The fuel filter is located under the vehicle, mounted on the frame rail on the driver's side.Relieve the fuel system pressure.Refer to Fuel System for the proper procedure.Raise and safely support the rear end on jackstands.
It's on the left side of the engine block, attached to the engine.You can follow the upper radiator hose, and it attaches to the thermostat housing on the engine side.
on the driver side under tht hood
This is something where you get what you pay for. I have a Snap-On Modis Ultra - it certainly works well, but isn't cheap by any means. Same with the scan tools available from Matco, Cornwell, and Mac. Altel's aren't particularly cheap, either. I know that the Snap-On Verus is their top of the li...
Should be at the bottom corner near where the footwell and dash intersect on the driver's side.