Whats the horsepower of a 1999 gmc sierra?
With tow/haul equipped transmission (button on end of shift lever) and a class 5 trailer hitch - 12 500 pounds.
The spare tire lowering handle is probably located under the rear seat on the 1999 GMC Sierra, if the vehicle is an extended cab. If it is not the extended cab, look behind the driver's seat for the handle.
The availability of diagrams will depend on a few variables including the year of your vehicle and how much of the vehicle is factory original. For original equipment diagrams, check your local auto parts stores for repair books for your specific vehicle published by companies such as Chilton's o...
The light is on because there is a problem with the air bag system. Until the problem is fixed the light will continue to illuminate. Once the problem is fixed the light will reset itself.
10k with a weight distributing hitch. Probably around 18k with a fifth wheel or gooseneck hitch. Normally these weights were on the door panel plate or in the glovebox. There should be a combined weight max, but type of hitching really determines the max. These weights are with properly equipped ...
Will the 4L60E transmission out of a 1997 Chevy 350 motor z71 4x4 fit into a 1999 GMC 294 motor Sierra 4x4?
Yes. The 4L6oE was intended to be used with the 4.3 - 5.7 liter engines.
Could be a bad throttle body
Vehicle weight information is on the drivers door tag.
1989 GMC Sierra C/K 1500 The 4.3-liter V-6 is rated at 160 horsepower and 235 foot-pounds of torque.The 6.2-liter V-8 produces a maximum of 126 horsepower and 240 foot-pounds of torque.The only available transmission is a four-speed automatic with overdrive.
next to the plenum under the hood it has 2 connectors on it and should be visible
A base, regular-cab 2015 GMC Sierra has a Manufacturer's Suggested Retail Price (MSRP) of $27,800.Double-cab models start at $31,825 while Crew Cab models begin at $36,225.Start climbing trim levels and adding options, and these prices can climb by tens of thousands of dollars.
The online stores that sell Saucony shoes would have them listed as part of their sales items. One such online store that sells them is www.saucony-running.com.Your vehicle may have inside cabin air filters that are plugged. You can buy replacements at your local auto parts store. The filters are...
it is easier to do it with the engine out of the truck but what you need to do is use a hammer and a chizzle which is rounded and not sharp because you want to place it on the inside of the cap and tap only on one side so the other side pops out towards you and just pull it out with your hand.DO ...
Across the board, towing capability has increased, with the 4.3-liter V-6 rated to tow up to 8,000 pounds, and the 5.3-liter V-8 with Max Tow Package offering up to 11,600 pounds.The potent 6.2-liter V-8 10-speed automatic, meanwhile, is now only offered with 4WD and can pull up to 12,200 pounds.
How do you remove the nut that holds the fan clutch to the water pump on a 1999 gmc sierra pully keeps spinning thanks jp?
the nut is reverse thread. u have to get a air impact hammer to knock it loose. it loosens to the left.
The 2001 GMC Sierra 1500 dashboard speakers measure 4.5 inches in diameter. The front door speakers measure four inches by six inches. The rear speakers measure five inches by seven inches.
THere is the Evap canister and associated lines and valves. The engine will not operate properly with this removed.
A 1992 Sierra GMC will hold approximately 34 gallons of gas. Drivers should expect gas mileage between 14 and 17 miles per gallon.
My 2000 Sierra with 5.3 liters V8 needs 6 1/2 quarts of oil
I believe you turn the ignition on, press the gas pedal to the floor three times, watch light flash five times and it's reset.
Shims are used only when the starter/ ring gear are too tightly meshed, which can be caused by incorrect tolerances at the factory between the starter/bellhousing. They are not used on a particular year, model etc. Try it without a shim first; if it seems to sound/start fine then it will be fine ...
The RMK600 produced 105hp in 1999. For comparison the 2014 RMK600 is now making 120hp.
The starter of the 1994 GMC Sierra 1500 pickup is located on the dashboard. It is usually attached by a small wire.
you have to replace the whole module if I am not mistaken, first remove the steering wheel cover and then there should be 2 pins you will have to get to and push simultaneously to remove
There is a lot to this. You have to disconnect the battery and should drain the capacitor for the airbag. Then you need to pull the steering wheel after you remove the airbag. Then you can access the internal connections for the switch. When you put it all back, you need to make sure that the spl...
1 Remove the plastic triangle piece above the panel where the vent window normally is.There are two tabs that push into some slots along the top edge.I used a small screwdriver to pry the panel up enough to grab and pull.2 Remove the control panel in front of the arm rest.
most likely a 12 bolt 373 ratio, but it can vary depending on the model.
If the motor is still carbureted the fuel pump is mounted to the driver's front side of the engine block.The fuel pump is mounted on top and inside the fuel tank.
To turning off the Oil Life Light on 2007, 2008, 2009, 2010, 2011, 2013 GMC Sierra, conform to the following instructions: Turn the ignition on without starting the engine.Press accelerator pedal to the floor three times within five seconds.If the “Change Oil Soon” light flashes, the system i...
WWW.AutomotiveFourms.comDepends time of year and where you live.Most North American regions 10w30 is standard.Colder temps 5w30. You could call a Chevy dealership service dept.
I think what you mean is the gmc wiring system does not have a dedicated brake lite wire. I am trying to find the supplier for (american technology ) company name, they have a module PN at-lc-1 that enables you use the turn signal wires. I could go on with explanation my typing skills suck
Just buy a set of custom plug wires designed to fit perfectly. Lay the new wires out and sort by length. Now remove just one old plug wire. Caution: "Remove, and replace them, one at a time, so you will not get them confused or mixed up." Place a very small amount of dielectric grease inside the ...
Make sure that the parking brake is fully released and the brake warning light is off before driving.To release the parking brake, hold the regular brake pedal down, then push down momentarily on the parking brake pedal until you feel the pedal release.Slowly pull your foot up off the parking bra...
The 2002 GMC Sierra: temperature sensor is located on the front of the engine. The sensor will be just above the thermostat housing.
The 1996-1998 vortec 350 was an updated version of the older vortec style fuel system used on the smaller v6 engines. All eight injectors are mounted inside the intake manifold. You have to split the intake manifold and remove the upper portion. Once inside you can remove the Central Sequential F...
If the bulbs check good, replace the flasher relay.
Turn the ignition to run (one position before starting engine). Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds. If the "Oil Life Reset" appears the system is resetting. Turn the ignition off and then start the engine to verify the indicator has been reset ...
Transmission Fluid Level Check GMC Sierra 1500 (2014-2018) Getting Started.Open the Hood.Remove Dipstick. Access point for transmission fluid.Check Level. Insert dipstick and pull it out to determine level.Add Fluid. Determine correct fluid type and add fluid.Replace Dipstick. Put the dipstic...
It is not uncommon to removed the bed of a pick-up, but it might be more trouble than it is worth. So, it really depends on what type of work needs to be done.
A tick in a lifter is likely caused by poor fuel. Using a higher octane fuel will often stop the knocking or ticking.
Unfortunately it is built into the fuel pump which is located in the tank.Good luck
Behind the fuse panel in the driver's side dash.
There are four oxygen sensors for this vehicle - two for each bank of cylinders. They are located on the exhaust pipes just ahead of and after the catalytic converters - sometimes referred to as "upstream" and "downstream" of the catalytic converters. Bank 1 refers to the bank of cylinders where ...
How to Reset a Change Engine Oil Light on a 2002 GMC Turn the ignition to the "on" position and wait for the dash lights to illuminate.Press the gas pedal three times within five seconds. Wait for the oil light on your dash to blink for five seconds and then shut off. The "change engine oil" ...
it could be low oil level, oil pump going bad, oil presure sending unit going bad or the oil pressure guage going bad if you don't hear the valves making it may be the pressure uit or the guage if you hear a noise coming from the enine do ot run it any longer it may cause more damage
Fixing the problem which causes it would be the first step.
how long does it take to put a water pump in a 2002 gm sierra truck
First of all, you need to buy the parts youll need. Youll need three things, a dash kit, harness and antenna adapter. You just need to get a standard GM wiring harness($20). Then you need to get a dash kit, the new radio kit replaces the dash piece where your two center vents are, so you need to ...
Car Radio Battery Constant 12v+ Wire: OrangeCar Radio Accessory Switched 12v+ Wire: YellowCar Radio Ground Wire: Black/WhiteCar Radio Illumination Wire: BrownCar Stereo Dimmer Wire: GrayCar Stereo Antenna Trigger Wire: N/ACar Stereo Amp Trigger Wire: N/ACar Stereo Amplifier Location: N/ACar Audio...
Yes, but the ECM of the 95 would have to be reflashed to remove the interface with the (electronically controlled) automatic transmission.
The air bag module detected something wrong with the system.
Produced only in 1991, GMC built 2,995 examples of the original Syclone.Based on the Sonoma compact truck, it became the quickest pickup truck on the market, thanks to its turbocharged 4.3-liter V6, which put out 280 hp and 350 pound-feet of torque.
I have a Chevy 2002 HD1500 with a 6.0L with a Bullydog Power Pup Gas and I got 1.2 MPG better than stock on regular setting. I have been playing with multiple settings and fuels. With 91 octane premium and the perfomance setting I actually lost about 4 MPG. I was told to try lower octane as highe...
Bank 1 = Cylinder 1/Drivers SideBank 1 Sensor 1 = Upstream (before cat) Drivers SideBank 1 Sensor 2 = Downstream (after cat) Drivers SideBank 2 Sensor 1 = Upstream (before cat) Pass SideBank 2 Sensor 2 = Downstream (after cat) Pass Side
Duramax uses 15W40It depends on the engine. For the 4.3 V6, ~5 quarts (4.5 with the small oil filter, 5 with the big one). The 4.8 , 5.3, and 6.0 V8 should all be ~6 quarts. The 8.1 V8 should be between 6.5 and 7 quarts, depending on the filter. The LB7 series of the Duramax 6.6 diesel is listed ...
It is located on the back of the block, right below the intake manifold, on the right side of the motor (looking from the front). When I found it, I couldn't actually see it. The intake needs to be removed to be able to see the OPSU and replaced.
I wouldn't.1. You will lose engine power. You need some back pressure for the engine to function properly.2. You will never pass emissions.Why would you want to do this? What year is it?not true! you don't need back pressure for the engine to run properly, that's like the bigger the better bunch ...
I specialize in spark plugs and gmc Sierra vehicles please call 870 9733 and when someone answers the phone ask for Steven underwood. I'm glad I could help!
A 1998 GMC Sierra SL Extended cab 4.3 V6 engine rear wheel drive truck has a 25 US gallon fuel tank.
There is two on that vehicle. Both are located in the exhaust system between the engine and the muffler.
Because the fuel filter is located inside the fuel tank and is part of the fuel pump module. The fuel filter by itself is not serviceable.
On the rider side firewall in the engine compartment ?
How many onces for 134A refrigerant does GMC Sierra use?
The Owner's Manual will have a diagram of the fuel system in the 1999 GMC Yukon. If you do not have a copy of the owners manual, you can contact GMC and they should be able to resend you a copy.
All the door power windows are protected under one circuit. If one door power window doesn't work, chances are the problem is within that one door, be it switch, motor or wiring.
Most new trucks have a plug you can hook a brake control up to and should have a plug in the back around the bumper some where it may take some looking under the truck but i bet its there any try a uhaul center for the the right fit as brake controls can be diffrent
check the ground for the lights
If you have the code or codes, just post them here.
Locate the main engine fuse box on the 1999 GMC Savanna van. In the fuse box look for the fuse marked ECU. Pull this fuse out wait 5 seconds and reinsert is. This will reset all codes on the computer.
14,000 lbs. or more, depending on specifics. Lots of variables which will affect this... steel or aluminum wheels, wheelbase, what type of body is mounted to it, etc... a garbage compactor, a water tanker, and a dump truck will all have different curb weights.
Yes, but if you're in a state which does emissions testing, be mindful the vehicle will be held to 2004 MY standards, not 1999.
There isn't much information in that question. Is it cranking? If not, it could be battery, battery terminals, starter, keyswitch, neutral safety switch... who knows what else. If it's cranking but not catching, always go back tot he basics; compression, ignition and fuel. If any one of the three...