What size socket fits a 2000 ford explorer driveshaft bolt?
Place a 3/8-inch (0.9 centimeters) socket in the socket wrench, fit it over the drain plug's nut and turn it counterclockwise.The oil drain plug should open easily, draining the used oil from the engine.Make sure to place a bucket and some newspaper under the car's engine to catch all the drainin...
If you are replacing the old sensors, you can cut off the wires at the sensor and slip a 7/8" box wrench over the sensor for removal. Use the open end 7/8" wrench to install the new one. Tighten the new sensor as you would a spark plug.
Ford - Vehicle Bolt Pattern Reference YEARMAKECOMMENTS2001Ford5 lug 4.5 inch 114.3 Standard Offset2002Ford5 lug 4.5 inch 114.3 Standard Offset2003Ford5 lug 4.5 inch 114.3 Standard Offset2004Ford5 lug 4.5 inch 114.3 High Positive Offset104 more rows
different part numbers. I don't think they interchange.
Bolts are categorised by their thread size.The standard socket size for a bolt with a three quarter inch thread is 1 and one eighth inches. Heavy head bolts use a one and a quarter inch socket.
The optional size battery was the Motorcraft BXT-65-650 battery( that's BCI group size 65 , 650 cold cranking amps )In a 1997 Ford Explorer for the 4.0 liter OHV and the 4.0 liter SOHC engines itwas the optional battery , and the standard battery if you had the 5.0 liter V8
The 2002 Ford Explorer has a 22.5 US gallon fuel tank capacity.
Tire size for all models is 255/55R-20.All Explorer models are equipped with a spare tire.If the object punctures the tire and comes back out, the sealant is designed to fill tread punctures up to a quarter-inch in diameter.
where is the starter located on a 2000 ford explorer the starter motor is located underneath the engine, at the point where it attaches to the transmission on the passenger side.If you start at the battery, and follow the positive (+) battery cable, it will lead right to the starter.
It'll bolt up to the engine, but the problem is that you'll either have to fabricate a cover for the rear of the engine and an adapter to mate the output shaft to the driveshaft. The difference between a 4x4 transmission and a 4x2 transmission is that the 4x4 transmission was designed to bolt up ...
There are no grease fittings on this vehicle. Many aftermarket parts do have them, though.
If not, stick to SAE and/or metric sizes.Drive size: Both metric and SAE sockets are available in three drive sizes: ¼-inch, 3/8-inch and ½-inch.Each requires a different ratchet and other accessories like extensions.Smaller sockets typically use smaller drive sizes, while larger sockets use the ...
There are four common socket sizes: 1/4 inch (0.6 centimeters), 3/8 inch (0.9 centimeters), 1/2 inch (1.3 centimeters) and 3/4 inch (1.9 centimeters).In-between sizes are available too, starting with 1/4 inch (0.6 centimeters) and increasing every sixteenth of an inch (0.16 centimeters).
They came with 16 or 17" in 6(steels) 6.5 or 7 inch widths (aluminum rims) aluminums have 12mm offset. If they are factory rims the driver's door/jam sticker will give diameter and width, on the back of the rim spoke will also give this info and part#. If you want to measure it yourself diameter ...
The 2001 Ford Explorer Sport ( the Sport is the 2 door model of the Explorer )came from the factory with the ( Motorcraft BXT-65-650 battery )* that's BCI group size 65 , 650 cold cranking amps *
`there is no order just do one at a time so you wont cross and put the wrong plug wire on the wrong plug
According to the 1998 Ford Explorer owners manual :The four door gas tank is ( 20.8 U.S. gallons )
It takes ½ X 13 thread (¾ head) and the two on top are slightly shorter than the other 4, total of six, two on top, 2 in middle and two more for starter and use grade 8 bolts
Battery keeps running down when you are driving. Your battery light should be on if the alternator is bad. Check the voltage at the battery with a digital DC volt meter set to the 20 volt scale. You should read from 13.5 to 15.5 volts with the engine running at idle. If not the alternator is susp...
Assuming this is an automatic transmission, Mercon V ATF.
Yes, it is a rebadged version of the Ford Explorer.
Warning lights are important to pay attention to and know warning lights. If seat belt lights flash, and an air bag light flash, it means there are problems with both parts.
It means to check the gauges because at least one of them is out of its normal range.
Unlock all doors using the power door lock switch on door panel. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Within 20 seconds press any button on first keyless remote. Within 20 seconds, press any button on second keyless remote. Turn ignition...
If you can't find the 15" wheels you want, we do have some options available in a blank drilled wheel to be drilled to your Chevy S10 trucks 5x120.65 bolt pattern.15 inch 5x4.75 bolt pattern wheels come in variety of different sizes such as 15x6, 15x7, 15x8, 15x9, and 15x10.
No, 2mm is a big difference, the hub size matters also, the 5x112 is a bolt pattern for mercedes, volkswagen, audi, and the factory wheels are hubcentric with ball seat lug bolts, most other cars are conical seat lug nuts and lug centric, so if you tried to use them you would nev er get all the v...
The best way it to take your Ford Explorer to the nearest Ford Dealer. He will doubtless employ mechanics who will be glad to replace the headlight assembly.
we just bought one used like a year ago and my husband found it somewhere inside the rear left corner panel where the jack is stored at it is a 5 digit code once u get it after making sure its correct type it in and hit***4 unlocks all doors***8 and 9 together locks them
There are not any unless parts have been replaced and the new parts have them.
Standing in front with the hood open, just to the right of the air filter box . Will have wires going to it. ( 4.o engine)
You may need to consider the hub diameter as well as the bolt circle.The initial list I found for that bolt pattern is:Acura TSXChrysler Concord/IntrepidDodge CaravanFord MustangHonda Accord, S2000, CRV, CivicHyundai TiburonInfinity G35Mazda 3, RX8Mitsubishi Diamante ('99+), 2G Eclipse, 3000GTEag...
A 1 3/16" or a 30mm should work.
You will need a 35 mm socket.
Chevrolet - Vehicle Bolt Pattern Reference YEARMAKECOMMENTS1998Chevrolet5 lug 4.75 inch or 121 mm Standard Offset1999Chevrolet5 lug 4.75 inch or 121 mm Standard Offset2000Chevrolet5 lug 4.75 inch or 121 mm Standard Offset2001Chevrolet5 lug 4.75 inch or 121 mm Standard Offset104 more rows
the bypass hose is 5/8" on one end and 3/4" on the other end
1999-88 BUICK - Regal (FWD)1999-86 Century (Some 100 mm)1999-86 Le Sabre (FWD)1998-85 Electra, Park Avenue1993-86 Riviera1994-86 CADILLAC - Seville1994-85 Deville, Fleet Wood, Brougham1994-85 & 78-67 Eldorado1999-97 CHEVROLET - Malibu (FWD)1999-95 Monte Carlo1999-90 Lumina, Lumina APV1991-82 ...
When the dealer attempts to reinitialize our 2000 Ford Explorer and it doesn't work what next can be done?
Do you mean to reset the computer? If it did not work and the check engine light came back on then the problem that caused the ECU to set the check engine light has not been repaired. Take it back to the dealer.
A general rule of thumb is to try and keep your rims about 1-4 inches skinnier than the width of your tires.If you have 26x9-12 front tires and 26x11-12 rear tires you would want to find 12x7 front rims and 12x7 or 12x8 rear rims.Either would work just fine.The same goes for the 14 inch sizes.
Meet The 2020 Ford Explorer: With all other options selected, the Limited Hybrid checks in at $61,155.Similarly, the hotter ST with its fully equipped price of $63,300 is just $1,310 away from a $64,610 Platinum.Never the less, a Platinum outfitted with every factory option is the most expensive...
SAE sets standard sizes and grades for bolts.Grade Is a statement of strength and hardness. Most auto hardware tends to be grade 5 and some high strength stuff is grade 8 or grade 12
How do you get the bolt out to remove roll pin from spider gears in and 2001 ford 10 bolt rear end have used a 6 point impact socket yet bolt will not give. any suggestions any special tools?
I have had this problem before on a GM 10 bolt. What I had to do was drive out the spider gear pin using a brass drift and a large hammer, thus shearing off the retaining bolt into 3 pieces. Once this pin is out, what's left of the retaining bolt will come out much easier. I can't imagine why the...
Acceleration and Power.The 2019 Ford Explorer comes standard with a 3.5-liter V6 engine that puts out 290 horsepower.Optional engines include a 280-horsepower, turbocharged 2.3-liter four-cylinder and a twin-turbocharged 3.5-liter V6 that produces 365 horsepower.A six-speed automatic transmission...
Spindle nuts very from 30mm to 34mm
ATV tire explaination: ATV tires are listed in a set of three numbers, generally separated by dashes (25-10-12), or by an 'x' (25x10x12) or a combination of the two: 1st Number = The overall tire height when inflated (Ex.25x10-12 is 25" tall).2nd Number = The overall tire width when inflated (Ex.
Best way to find out MPG, is to fill up the tank with gas. Reset the tripometer at the gas station just before/right after you fill up. Drive about 100-200 miles without putting gas in, and once you have went at least 100 miles, fill up the tank again. Check to see how many gallons it took to fil...
The towing capacity of a 1993 Ford Explorer was a maximum of five thousand six hundred pounds. This does depend on the equipment, etc.
check gage light on 2004 ford explorer and fuel reads empty.Turned off on me once, while at a red l
2003 Ford Explorer Sport UtilityOriginal MSRP / PriceCity MPG / Hwy MPGExplorer 4dr 114' WB 4.0L XLT Sport AWD$32,425 / N/A15 / 21Explorer 4dr 114' WB 4.6L Eddie Bauer$33,900 / N/A15 / 19Explorer 4dr 114' WB 4.6L Eddie Bauer 4WD$36,125 / N/A14 / 19Explorer 4dr 114' WB 4.6L Eddie Bauer AWD$36,...
you have to take the driveshaft out 2 fit a gaiter so if your driveshaft is warn you mite aswell fit a whole new drivshaft you have to take the driveshaft out 2 fit a gaiter so if your driveshaft is warn you mite aswell fit a whole new drivshaft
k050705 without AC k050835 with AC Carquest part #s
The stock rims are 15"x6", stock tire size is 205/60-15.The aspect ratio of the R-comps will be either 55 or 50.Could I possibly stuff a 215 or even 225 width tire onto the stock rims? 215's will definately fit, 225s might, but you will need the taller 55 sidewall.