What is the Spark Plug gap for a 1990 Ford F 150 4.9 liter 6 cylinder?
On a 2002 Toyota 4-Runner 3.4L V6, the spark plug gap is .044", but there's a caveat. The OE factory recommended plugs (DENSO or NGK) are designed with dual-ground electrodes, which are pre-gapped at .044" and therefore a gap adjustment is not required. For this particular application, the dual-g...
Spark Plug Gap is .044
There are two temperature sensors. One is under the #6 intake and sends signals to the temperature gauge. The second one is in the thermostat housing and signals the ecm module.
the owner manual says the gap should be .039 - .043 inches.
The spark plug gap for a 1985 B2000 Mazda with a 2.0 liter engine is .8 mm. This is equal to .031 inches.
The manufacturer's recommended spark plug gap is .040".
Depends on the spark plug you use. The ACDelco part number R43TS6 uses a .060" gap.
153624, distributor turns clockwise, #1 is front cylinder
On a 1994 Ford Taurus :firewall1-----2-----34-----5-----6front of vehicle > driver
( also , the distributor rotor turns CLOCKWISE , the distributor cap is installed with the marked # 1 position facing AWAY from the engine , and the engine cylinders / spark plugs are numbered 1 through 6 , from front to rear )See this page,http://autorepair.about.com/library/firing_orders/bl-fo-...
If engine is not burning oil, gap it at .35. If it burns oil, buy a hotter plug and gap at .35===========================================================I was looking at one of Fords websites and it shows :For a 1993 Ford Escort , 1.9 liter four cylinder engine :The platinum spark plugs are gappe...
Help us out here 4.9 liter what?
1987 FORD THUNDERBIRD 2.3L 140cid L4 MFI Turbo (W) : Ignition : spark plug gap .034 3.8L 232cid V6 TBI (3) : Ignition : spark plug gap .054 5.0L 302cid V8 MFI (F) : Ignition : spark plug gap .050
The PVC valve is on the top valve cover near the firewall. You need to get up into the engine area and look at the back of the engine. You can't see it unless your over the top of it.
The spark plug gap for a 1983 Ford Ranger 2.8L is .044"
The proper gap is 0.06
The recommended spark plug gap for a 2003 Ford Expedition 4.6 is .054"
SPARK PLUG (IZFR6K11) (NGK) Iiridiumshould come pre-gapped1.0-1.1 mm (0.039 - 0.043)
The towing capacity of a 6-cylinder Ford E-150 conversion van is 1,200 lbs. It also has a 3-speed automatic transmission and a 4.9 liter engine.
A 1995 Nissan 6 cylinder pickup should have a spark plug gap of .044 inches. These spark plugs come preset from the factory.
The spark plug gap on a 1986 Chevrolet S10 4 cylinder pick up truck should be set at .060 inches. The spark plug for this vehicle may be purchased at any auto parts store.
What is the proper spark plug gap for a 2001 Ford Taurus with a 3.0 liter engine with single over head cam?
The spark plug gap is .042" to .046".
4.6 L - V8 engine ( .054 inch ) 5.4 L - V8 engine - L and Z engine codes ( .054 inch ) 5.4 L - V8 engine - M engine code ( natural gas .044 inch ) The engine code is the 8th " character " of your VIN according to motorcraft . com
If this is an automatic transmission, the switch is located on the driver side of the transmission housing where the linkage plugs into the transmission.If it is a manual transmission the clutch safety switch is located near the top of the clutch pedal.
.039-.043 and you can also look under the hood and read were it says tune-up specifications and it should sometimes say plug gap ...
For a 1997 Ford E-150 . 4.6 liter V8 engine :4 - 83 - 72 - 61 - 5front of vehicle
Need make & model of the vehicle. --------------------------------------------------------------------------------------On a 1997 Ford F-150 :The spark plug firing order for the 4.2 liter V6 engine is ( 1 - 4 - 2 - 5 - 3 - 6 )The engine cylinder locations are numbered :firewall3 - 62 - 51 - 4...
On a 1994 Lincoln Continental , 3.8 litre V6 engine :Check your Vehicle Emissions Control Information ( VECI ) decal , located in thefront of your engine compartmentIt will show what type of spark plugs to use and the spark plug gap
The fuel pressure regulator on a 2002 Ford F-150 5.4 liter V8 is located just behind the fuel rail. It is situated near the fuel injectors to ensure proper flow.
spark plug gap for 5.0 liter engine is 0.054 inches
Do you have a diagram of the firing order from the distributor cap to spark plug on a 1989 Ford strait 4.9 6?
do you have a picture of a 1988 ford escort lx distrbutor firring order
The spark plug gap for a 1995 Chevrolet Van 350 TBI is .035 inches. This is equal to between .8 and .9 mm.
The spark plug gap for a 1995 Subaru Legacy is .044"
It depends upon the engine. Engines with higher compression require a narrower gap. If this is for a marine application (IE:outboard motor) 0.030 is the gap required for most, but you should double check.
Start at vacuum source at engine and follow line-by-line
I have an owners ski doo manual for 1996. It lists "touring, skandic & formula s/sl series. It does not give the engine size. For all these machines, it says NGK spark plug BR9ES, gapped at .45mm or .018in.FYI, it also lists the drive belt as 414 8833 00. I have a 1996 ski doo owners manual. ...
Bosch OE fine wire Iridium spark plug gap is preset. Do not gap. Other aftermarket spark plugs range from .040" to .044" gap.
Depends on the type of spark plug purchased, some are pre-set and not to be adjusted and some are .040 or .044. More info needed.
This information can be found in your owner's manual, or under the hood on a placard. If you do not have one, then you need to get one. Dealer, E-Bay, Salvage Yard, and many online sites are sources for a manual. Use Google and search with the term, "Automobile Owner's Manual".
This can be found in your owner's manual and under the hood on a placard.
When changing the spark plugs of a car it is important to leave the right gap size. The Spark plug gap for this car is .042 inches.
At least, according to Car & Driver. When you think of fast Ford F-150s, the Raptor (or the dearly departed Lightning, RIP) is probably the first truck that comes to mind. At 5.1 seconds to 60 mph, the F-150 Limited is just the second quickest truck the publication has ever tested. It's...
The recommended spark plug gap for a 1999 Honda CBR600F4 is .035", according to the manufacturer NGK. The correct plug is CR9EH-9. Or, for the iridium upgrade, it is CR9EHIX-9.
The spark plug gap for a 1998 Nissan Pulsar with the 1.8L L4 is .044-inches. The Nissan OE plug for this application is the NGK Laser Platinum part#4045.
.030 is the correct gap.
the cylinder numbers, from the front to the back are (drivers side) 4 5 6 [front] [back] and the (other side) 1 2 3 the firing order is 1-4-2-5-3-6 coil pack is numbered 1 2 3 (left side) front Back 5 6 4 (right side)
Hello, If you are talking about the gear on the fly wheel, 1. remove the fly wheel from the back of the motor. 2. Remove any grease and oil. 3. put it into the kitchen oven at 400 deg. for about 20-30 min. 4. Then use pliers to remove or relocate the gear. The gear is made of softer metal than th...
I believe for 1970 and 1971 , the point gap for the 360 cubic inch V8 ( 5.9 L ) in the Ford 1/2 ton truck is ( .021 inch / point dwell 23 to 29 ) The only other point gap mentioned for that engine in other years and 3/4 ton or 1 ton is .017 inch
Below the exhaust manifolds between the manifolds and the top of the oilpan.
2018 Ford F150 TruckOriginal MSRP / InvoiceHorsepowerF-150 XL 4WD SuperCrew 6.5' Box$40,010 / $38,009395F-150 XLT 2WD Reg Cab 6.5' Box$33,300 / $30,969290F-150 XLT 2WD Reg Cab 8' Box$33,600 / $31,248290F-150 XLT 2WD SuperCab 6.5' Box$36,210 / $33,67529040 more rows
Here is your answer: http://www.autopartswarehouse.com/mmp/mitsubishi~mirage~spark_plug~parts.html
It is important to remember the spark plug gap when changing the spark plugs of a vehicle. A 1998 Mazda B2500 has a spark plug gap of 0.042 to 0.046 inches.
Gap will be preset at the factory no need to re-gap. The gap is .044.
If it worked recently duct malfunction in dash if not check to see if water hoses going into firewall. Should get warm as car doesNeed the symptoms it has.
A 1995 Chevy Van with a 454 engine will have a spark plug gap of .060 inches. A difference of .005 (give or take) should not affect the engine's starting capabilities, however.
What's a PVC? Perhaps you mean PCV (Positve Crankcase Ventilation) valve.
On a 2007 Ford F-150 , 4.6L V8 engine :The firing order is ( 1 - 3 - 7 - 2 - 6 - 5 - 4 - 8 )It has the Coil On Plug ( C.O.P. ) ignition system with ( 8 ) individual coilsThe engine cylinder locations are numbered :firewall4 - 83 - 72 - 61 - 5front of vehicle > driver
The gap adjustment can be fairly critical, and if it is maladjusted the engine may run badly, or not at all.A narrow gap may give too small and weak a spark to effectively ignite the fuel-air mixture, while a gap that is too wide might prevent a spark from firing at all.
0.052-0.056 in. make sure the engines cold when removing the plugs on this engine,this is an aluminum head and thread damage is common. also have compressed air handy to blow the dirt and debris out of the plug wells before removing the plugs.
According to one of Fords websites :For a 1992 Mercury Topaz , 2.3 litre four cylinder engine :( the spark plugs are gapped at .054 inch )
With the 2.2 L engine and ACDelco R42LTS spark plugs, the gap is .040".With the 4.3 L engine and ACDelco R44LTS6 spark plugs, the gap is .060".Platinums are gapped at 0.60, and iridiums are typically gapped at 0.40... you shouldn't try to change the preset gaps.
Yes, one defective spark plug can cause the check engine light to come on. That one plug can be not firing properly and this would cause a miss on that cylinder. That miss would cause the ECU to set a fault code. The code will tell you what component is being effected. My advice is to replace tha...
A large vacuum leak can do that.
thanks for making me login and go through several pages just to find the f-word oil capacity in the middle of the oil change
For the 1996 Ford Explorer 4-wheel drive 4.0 liter 6-cylinder engine, the head bolt torque for step one is 44 ft. lbs. For step two, the torque is 59 ft. lbs., and for step three, turn an additional 80 to 85 degrees.