What is the estimated cost for a replacement key for a 2002 ford ranger?
Find out for yourself: www.fuelEconomy.gov
If it is the ignition key, then you will be making a trip to the dealership, so that they can program a new key for you. That key should be chipped so a regular cut key will not work.
From what I have seen in my area the average labor per hour cost in a licensed certified shop is $90.00 + per hour
Contact a Ford Dealership.
Let the engine cool down. Locate the lower water hose at the bottom of the radiator. Unfasten the clamp or clamps, pull on the hose and the water comes out.
Can the transponder key switch in a 2000 ford ranger be replaced with a conventional key switch would like to do away with the transponder key?
Yes ... But it requires a working transponder key, the head of it actually .. Here's what I would do .. Get a good mechanical copy of your key made by a locksmith. Have them cut it to code and make sure it works. Take your old transponder key and cut or break the shaft but do not damage the plast...
The key is a cylinder about 2-3 inches long that has a hole in one end that fits on the end of the jack extension rod. The other end has a six-lobed pattern that fits into a key in the spare tire winch (at the end of a plastic tube reached via a hole in the rear bumper). There are multiple patter...
The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.
approx. 100 dollars w/ seal, differential cover gasket material (RTV) and labor
Check the fuse Check to see if you are getting power to the switch Check to see if you are getting power to the motors - if so motor is bad
Looking on the website for O'Reilly Auto parts, alternators for the 4.0 SOHC V6 range from about $140 for a rebuilt alternator to $240 for an original OEM alternator. For the V8, it looks like $114 for a rebuilt off-brand alternator to $276 for an original OEM alternator. Changing an alternator i...
The code P1443 for the 1996 Ranger means that there is a problem with the EVAP Pressure Sensor. The real culprit might be the Vapor Canister Purge Valve since the EVAP Pressure Sensor rarely fails. The VCP Valve is around $60. Before purchasing this part, check all hoses around it for leaks.
more than likely a x 25 depending on the motor if it is a dual muffler of exhaust it mat be a z t56
Of, course , if you want to race it, you need a transporter to get it to the track, ($300,000 ) a crew of five or ten people, fuel, spare parts, tires, a spare body, etc.It used to cost about 1.5 to 2 million dollars to run one car for a season.Rule of thumb, it averages out to about $4,000 per p...
Depending if the key has a chip or not. If it does not you can go to home depot or lowes and make one cheap for like 12 $ if it has a chip they cant make it and you have to go to the dealership and they will do it for you which can cost up to 70$ from what my friend told me when he made extra one...
Take your title or registration to the Ford dealer and have a new one made, they can do it from the VIN but you will have to prove it is your vehicle.
You simply get your two original keys, sit in the car with the door closed, and then turn each key to position 2 on the ignition barrel (with the red lights showing on the dash), then remove each within 10 seconds per-key.You then insert the new key, turn it to ignition position 2 and remove it w...
The labor time for a 2000 Ford Ranger with a 4 cylinder engine is 10 hours, or roughly $900. It could be more depending on the year of your vehicle and for the 6 cylinder engine.
A small town repair shop qouted me $1,000 with tax. $500 on labor alone.
The cost takes into account the price for a new or used engine and the service charges. Used engine can be $1,250. Installing the engine can range between $262 - $574.
It's doable... what all is required depends on the application. You should probably plan on also replacing your transmission, as well.
$45 in parts + $150 in labor
Disconnect it from the engine and try to shake it with your hand. If it rattles it's probably okay.
Impossible to say. If it was totally rebuilt and done correctly, with proper service it should last as long as a new one. If it is a used transmission, who knows.
Remove the screws around the dash panel and remove the guage cluster. Be careful a lot of dashes have clips as well as screws. If it doesn't slide right out you are missing something. Once you have it out there will be little white retainers that hold in the lights. Usually a quarter of a turn is...
The 2002 Ford Explorer came in V6, V8 and Sport Trac models. There were different suspensions for each. If the 2002 Explorer had leaf springs these parts cost for wholesale can be around 140$. If the Explorer has coil springs a pair of two quality OEM replacements run around 70-100$. Maximum labo...
It takes ½ X 13 thread (¾ head) and the two on top are slightly shorter than the other 4, total of six, two on top, 2 in middle and two more for starter and use grade 8 bolts
Minimum machine to .988"Discard at or under .984"
You can get new keys made at the ford dealer with your title and registration showing you own the car. It is that easy. This works on any car so long as the ignition is the same as new which then matches the vehicle identification number on the car.If you're worried about your vehicle being broke...
Because you didn't change the rest of the ignition system. Plugs, Wires, Rotor, and Cap are a must for ICM replacement.
No. Different platform.
The 2002 Chevrolet Trailblazer has two different lower ball joints depending on whether it is a 2 or 4WD model. A low quality and budget lower ball joint can run around 5$ wholesale. A premium and preferable OE replacement lower ball joint is around 25$. The AC Delco Professional part# for a 2WD ...
The cost for a Chrysler car key replacement varies greatly based on where, and how it is carried out.Most dealerships will charge you upwards of $160, but United Locksmith is a much cheaper alternative.The process for a Chrysler car key replacement begins at $120, which will save you over $40 in ...
If an engine is equipped with a timing belt, the timing belt must be replaced at the service interval specified by the vehicle manufacturer regardless of whether or not any problem is visible, typically in the range of 60,000 to 90,000 miles.Your vehicle owner's manual should state the specific s...
You cannot "fix" it. But you can replace it in about an hour.
A: In short, to replace a Dodge Caravan key usually cost between $90-$400.
incomplete question. Try an 8 or 10 mm or repost with the car you are working on. 2002 is to vague.
The only powertrain currently available for the Ranger in the U.S.is a 2.3-liter four-cylinder gasoline engine mated to a 10-speed automatic transmission.As with other Ford diesels, the special emissions components would be integrated into the design of a production diesel Ranger.
1983-1992 Ford Ranger: 1983-1992 Ford Ranger Vehicle DimensionsRegular cab short bed (6′)Extended cab (First Super Cab was 1986)— Max Width At Floor54.3 inches54.3 inches— Width Between Wheelhouses40.4 inches40.4 inches— Inside Height16.6 inches16.6 inches15 more rows
Could be upwards of 1-2K - but if you drive it yourself, much cheaper. You can also hire someone to drive it out there, which might also be cheaper.
It is 28-45psi with engine running and 35-45psi with key on engine off.
I called Ford. They instructed my to look up the steering column from the pedal area, for a sticker with the five digit code. It is a bit difficult to get to but it was clearly visible.
Go to a Ford dealership with the VIN # and they will make you a new key.
i just had one replaced last week in a 96 model explorer, the starter was 160 and with labor it was about 250.00. or if you do it yourself you can get a good used starter or maybe a new starter off eBay for 50.00 maybe a little more or less, Jesse
For the 1983 model year, the Ford Ranger nameplate was applied to a model range, as Ford introduced its own compact pickup truck, replacing the 1972-1982 Ford Courier in North America.In global markets, Ford began use of the Ranger nameplate in 1998 in place of Courier, with all compact trucks na...
Yes, any tractor drivetrain will do
1983-1992 Ford Ranger: 1983-1992 Ford Ranger Vehicle DimensionsRegular cab short bed (6′)Regular cab long bed (7′)— Inside Length At Floor73.0 inches85.0 inches— Tailgate Opening At Floor54.2 inches51.9 inches— Max Width At Floor54.3 inches54.3 inches15 more rows
The 1995 Ford Ranger power window fuse can be found in the fuse box. The power window fuse will be the number 11 fuse.
2002 Ford Explorer Sport UtilityOriginal MSRP / PriceHorsepowerExplorer 4dr 114' WB Eddie Bauer$32,545 / N/A210Explorer 4dr 114' WB Eddie Bauer 4WD$34,510 / N/A210Explorer 4dr 114' WB Limited$32,545 / N/A210Explorer 4dr 114' WB Limited 4WD$34,510 / N/A21012 more rows
The starter solenoid should be located on the inside fender close to the battery. It will have the positive battery cable connected to it.
The 4.0 V6 is a powerful truck and a 2001 compared to a brand new F-150 probably has more torque because in about 2004 Ford started making low end torque F-150s and I dont know why.they are very good engines,only one problem i have found with this engine,is the spark plugs are a job to replace.
PATS is an acronym that stands for Passive Anti-Theft System (Ford also calls this SecuriLock).It is a security feature found on most (if not all) new Ford products, and what it does is disable your vehicle's starter unless your specially programmed key is used to start the vehicle.
The circuit has a short or is overloaded.
My son has a complete 1987 extended cab with everything good or better but a shot engine in Pueblo, CO. That's what happens when you never change oil. If you want write at [email protected]
usually bank 1 is the bank with # 1 cylinder in it and sensor # 1 is the front o2 sensor(usually in the manifold). You will need a O2 sensor socket or a 22mm wrench or deep socket.
The costs to replace the brakes in this car can range from $30 to $80. This depends on where the parts are bought, the part brand and who does the replacing.
This is a very common problem with the 3.4 engine. It depends on if you plan on doing it yourself of having a mechanic do it for you.Felpro gaskets are expensive just the gasket kit alone will cost about 160 so you would have to figure labor in to install it. I can't remember of the top of my hea...
O.D means that your'e overdrive gear is working, if you're rpms are higher than usual you can go to auto zone and get you're obd ii SCANED FOR FREE od is usually referred to as overdrive witch sp? means an extra gear helps you're mpgs. this should help
Ford Ranger (T6)RelatedMazda BT-50 JMC Yuhu Troller T4 Ford EverestPowertrainEngine2.3-liter EcoBoost I4 (petrol) 2.5-liter Duratec 25 I4 (petrol) 2.0-liter EcoBlue I4 (diesel) 2.2-liter Duratorq I4 (diesel) 3.2-liter Duratorq I5 (diesel)Transmission5/6-speed manual 6/10-speed automatic18 more...
How to Recharge Your Car's Air Conditioner By Larry Carley c2007 LOW REFRIGERANT If your air conditioner is not cooling well because the system is low on refrigerant, recharging the system with refrigerant should restore normal operation. This can usually be done with a few cans of refrigerant an...
yes they are the same. take heater lines loose from fire wall and take the screws out of the lower passenger dash board. (lines located in engine compartment)
If you lose the key and fob, you can expect a dealer replacement and programming to cost $200 or more, depending on the vehicle and the key's design.A Lexus dealer quoted $374 for a new key, fob, and programming, and a BMW dealer said replacement keyless fobs could be as much as $500, depending o...
The average cost of replacing a car key varies a great deal.The cost can run from $50, if you bring in a door or trunk lock containing all of the needed wafers, to around $500, if it's a luxury car with a proximity fob.Replacing keys to a car if you have duplicates is quite a bit less expensive.
The vehicle year, model and engine info needed.
What should the cost be fto replace a transmission on a 2002 silverado 1500 4x4 extended cab 4.8 ltr?
The transmission should be priced from $2000 - $2500 for the transmission.Labor to install transmission should be some where around 6 hours this price may vary depending on where you go for any estimate, that's why you ask how many hours they are charging you for.
Aprox $500 parts and labor.
A car loan estimator allows the purchaser to budget how much money they will need to buy a car. The calculator will also allow the purchaser to allocate funds for the upcoming interest payments.
The 2002 Ford Explorer has a 22.5 US gallon fuel tank capacity.
check fuse for fuel pump or may need a new fuel pressure regulator, its on the fuel rail.
That depends on the labor rate where you are; it ranges from 1.6hrs with a V8, 1.9hrs with a V6 w/o air, or 2.2hrs with a V6 w/air.
There are many sensors on that vehicle. Need to know which ones you are looking for.