How many lugnuts are on a standard car wheel?
AnswerDepends on the car.Most sedans and coups have 16 or 20 (i.e. 4 or 5 on each wheel). Midsize trucks often have 5 per wheel. Larger trucks, 6 per wheel. Large trucks (Ford F-250s and the like) 8 per wheel. Buses and larger vehicles can have 10 or more per wheel.
I'm sure there are literally thousands of wheels on a car, from the obvious like steering wheels, and tires to the not so obvious like the flywheel and the gears on the odometer
Answer: Apply lots of thin oil and let it work it's way into the joint to loosen any rust. Put the rest of the nuts back on and tighten them, then lower the car to let the weight of the car keep the wheel from turning. Then apply lots of force. Use an impact wrench or Uncle Louie's wrestling arm....
Checking engine oil is the same regardless of what transmission you have. You find the oil dipstick under the hood, pull it out, wipe it off, reinsert it, pull it back out again, and ensure the engine oil level is within the limitations specified on the dipstick by the "full" and "add" lines. Tha...
turn the car offDon't jack up the wheel until you loosen the lug nuts.Find some one who is good with a cutting torch, they can cut that nut off without damaging the rim. You will have to replace that stud or maybe the hub assembly.
The V8 engine used in the Clubsport R8 produces 317kw. . Cheers
This is the distance from the center of one wheel setting on the ground to the center of the opposite wheel on the ground.If you want outside of tread to out side tread you would have to add a tire width.From a little Googling it looks like cars are around 60 inches (1.5m) for tracking width.
While larger-diameter wheels and tires should improve handling and high-speed performance, lower-profile tires also tend to have a firmer ride and may be noisier than the smaller, standard rubber.A steel wheel weighs more than an aluminum alloy wheel, so the latter enhances performance by reducin...
You have to compare the size of the rims and wheels to one another.If the difference is way off,No,it won't work.If it's slightly bigger,the wheels might rub against the wheel well,which u don't want!I just know the basic's,but I'm not an expert.
Do you have to dissconnect the drive shaft on rear wheel drive with standard transmission when towing on car dolly?
No, you just put the transmission in neutral. This works for both a dolly and for flat towing.
16 if inflated with air or helium.800 or so if inflated with heroin.
Stabilizer Link Description There are usually two brackets toward the middle of the bar that hold the bar to the chassis underneath the car.At either end, the bar is attached to the suspension with short end links that come off of the bar at 90-degree angles.
Follow these steps: With your left foot, press the clutch pedal all the way down to the floor.With your right foot, step on the brake.Release the emergency brake, and once again, confirm that the gear shifter is in the neutral position.Turn the key in the ignition. The car should start up.
There should be a lock ring on the axle that prevents the wheel from sliding off while in service. Remove the lock ring and slide the wheel off the axle. You may need a lock rings pliers to remove it, or you might be able to do it with a small screw driver.
Approx 42 billion cars are running in India.
For both manual and automatic transmission equipped vehicles, the flywheel is actually attached to the rear of the engine crankshaft, not to the transmission itself. But cars that have automatic transmissions originally can have flywheels that are not compatable with manual transmissions. That is...
There are a wide variety of truck wheels. There are wheels for small pick-up trucks, military trucks, and "big rig" trucks. There are over 7 standard truck sizes for tires. Cooper Tire lists over 20 different sizes for truck tires. Another website lists over 100 truck tire sizes. Each tire fits o...
There were 4 wheels on the first self propelled vehicle, built by Henry Ford.
The number of wheels is variable according to the lorries size and the load it is able to carry. For instance, a small lorry, used for light loads, may have four wheels (as does a car), or dual-wheels on the rear axle and single wheels on the front. Larger, rigid lorries, and articulated lorries,...
Use the appropriate tool to loosen the lug nuts.Before jacking the car up, use your wrench or tire iron to break the lug nuts loose.Do not remove them completely, but turn them a quarter turn or so in the counter-clockwise direction each to make them loose enough to unscrew while the vehicle is i...
A truck has one front axle and one or more rear axles which typically have dual wheels on each side. Common configuration: one rear axle - 6 wheeler So apart from the steering wheel Caterpillar 797- B (biggest dump truck in the world) has 6 14 foot tires and the Australian centipede has 30 wheels...
got the same problem.. so far all I found was this.. http://www.garrettwade.com/jump.jsp?itemType=PRODUCT&itemID=105477haven't bought or used it yet..and here http://answers.yahoo.com/question/index?qid=20080518195536AAVm2yMyou out!!
My 2009 Chevrolet Silverado holds 26 gallons of gasoline.
It depends on the vehicle. You can find the specifications in the owner's manual and at many automotive websites such as Edmunds (dot) com.
Get some push pops and use the plastic pieces to push the ice cream up with to make the wheels
If your talking about changing the oil in the standard transmission, take it to a garage and let them do it. It is easy to drain but the new lube has to be pumped in.
It differs from types of semi's but the most basic semi with no trailer counting only one side is five wheels one in front and four on back. With trailer it would be nine with four being on one side of the trailer.
The tire of a car wheel has an outer diameter of 30 cm How many times will the wheel rotate on a journey of 5 km?
no. of rotations = 500000/3.142*30 = 5304.47 = 5304