Can you use a 1998 Jeep Grand Cherokee 4.0 fuel pump on a 1996 Jeep Grand Cherokee limited 8.0?
If the donor Jeep is the exact same year and has the exact same engine and transmission the answer is yes.
Idle speed is computer controlled and is not adjustable. Is the speed is incorrect, you have a malfunction with the idle airflow control motor, another sensor, or the computer could need reset. A weak battery can cause the computer to "forget" how to idle. Unhooking the battery for five minutes r...
42RE if it's an automatic, Aisin AX-15 if it's a manual.
dextron auto transmission fluid or power steering fluid
1996 Jeep Grand Cherokee Laredo 4 door SUV RWD 4.0L curb weight is 3,614 lbs.2008 Jeep Grand Cherokee Laredo 4 door SUV RWD 3.7L curb weight is 4,316 lbs.
A wiring diagram for the driver's door on a 1995 Jeep Grand Cherokee Limited can be ordered from the Jeep dealership. It can also be purchased at auto parts and major book stores.
It can be done, but it won't be a simple "plug and play" swap.
Tire/wheel balance,worn/loose steering components,
Unlock the doors with a key or remote.You need an advanced computer program. Go to Craigslist, look under services, auto locksmith, find one that is mobile and tell him you need a reset. It takes about 10 minutes.
Yes you can replace a brake line on that Jeep. Try to remove the bad line in one piece so you can bend the new one to match. Your local auto parts store can help you with the parts you will need. Bleed the system when you're done.
The water pump is on the front center of the engine.
Minimum spec at a warm idle is about 12psi. Normal is about 30 at idle. Should go 40-60 at 3000 rpm.
You have a problem with the EVAP Leak Detection Pump. You must first repair the problem that caused the ECU to set this code. Once the problem is repaired the code can be reset with an OBD2 scanner.
If your looking for an inertia switch, it doesn't have one.
1 Answer.john porter, the combination Fuel Filter/Fuel Pressure Regulator is remotely mounted to the vehicle body, above the rear axle and near the front of the fuel tank (Fig.5).
The fuel filter is located under the vehicle, mounted on the frame rail on the driver's side.Relieve the fuel system pressure.Refer to Fuel System for the proper procedure.Raise and safely support the rear end on jackstands.
Attach a fuel pressure gauge to the service port on the fuel rail.
Yes. There could be several reasons for engine to overheat.
It is located at the driver's fender side of the the throttle body.
Check to be sure that the dome light switch isn't turned off. Consult the owner's manual as to the location.
Max towing cap when adequately equipped, which may require engine and/or other drivetrain upgrades, 5,000 lbs.
The manufacturer's recommended spark plug gap is .040".
1999 Jeep Grand Cherokee Laredo 4.0 why cruise control horn and radio controls on steering wheel will not work?
Follow the harness... at some point, there'll be some type of quick connect fitting connecting it to the main harness to the CECU. That's your likely culprit.A good possibility is the "clock spring" is bad.
Under the hood, on the passenger side firewall, close to the passenger side fender.
6.5 Speakers both in-front and rear
A 1998 Jeep Grand Cherokee has a four speed automatic transmission.
Max towing capacity, 5000 US lbs when adequately equipped, which may require engine and/or other drivetrain upgrades.
The fuel pressure regulator on a 1994 Jeep Grand Cherokee is part of the pump module in the fuel tank.
It is considered a full time four wheel drive vehicle.
If you are asking about rear axle gears, no. The XJ has a corporate axle and the ZJ has a Dana axle.
I have found though my experiences that 99% of the time the fuel gauge sending unit in the tank has failed.
Can i use a radiator from a 1995 jeep Cherokee country to replace the radiator in a 1995 jeep grand Cherokee?
Yes, only if they have the same engine.
When facing the engine it's located on the top right hand side of the bell housing, it's very hard to change.
Press and hold the reset button about 3 seconds.it gonna be appear how many miles you need...it works..
Press the power door-lock switch on the keyless entry fob.Close the driver's side door.Leave all doors closed for about 16 seconds until the Vehicle Security Light on the instrument cluster stops flashing quickly.When the light flashes at a slower rate, this signifies that the system has been res...
Jeep Grand Cherokee 5.7L / 6.4L 2012, Inverted Roller Timing Chain by Cloyes®.Keep your engine's valvetrain and balance shafts in perfect time with Cloyes, the world leader in timing drive systems.No matter whether you need a belt,
It is a group 65. Most are 700-800 cold cranking amps.
What Causes Wrangler Death Wobble? Death wobble is caused by loose or damaged steering components, however, it can also be caused by incorrectly installing steering or suspension components.The first thing you should check is to make sure that nothing is bent or broken.
That is the first time I have heard the term auxiliary emissions control, a vehicle only ever has one emissions control system. Could you provide an obd trouble code so a proper diagnosis can be given
You'll find repair manuals at your local auto parts store.
Know what price you should pay to get your vehicle fixed.The average cost for a Jeep Grand Cherokee automatic transmission diagnosis is between $88 and $111.Labor costs are estimated between $88 and $111.Estimate does not include taxes and fees.
Mounted atop the transmission tail shaft.
Overheating the engine shouldn't effect the transmission. Overheating the transmission could.
You have to program it with a DRB (Scan tool).
Blower Motor Resistor: Testing and InspectionWarning: On vehicles equipped with air bags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (Ground) cable, then wait two ...
The starter will cost you around $100. The labor cost to install it will be around $75.
Never. Only have it drained and refilled, never flushed. Be sure and have it done when the vehicle hits 100,000 miles. Your owners manual will list if it needed before that.
Replaced fuel pump in1993 jeep grand Cherokee but still have to turn key over 10 or so times until fuel pump kicks in then it will start Replaced fuel relay still having problem?
I have the exact same problem. After replacing the fuel pump everything was fine. Now the fuel pump does not always kick on and you have to turn the ignition on and off until you hear the fuel pump kick in. Went to start this morning and fuel pump did not kick in, still wont. So I checked the rel...
Would like to put a complete 4.0 jeep motor and trans out of 2004 grand Cherokee into an old Chevy truck?
It could be done, but, IMO, not worth it. You'd be better off going with a GM small block and a 700R4 transmission.
Because there's an issue with your ABS system somewhere. What it is exactly, you're not going to know until you get the DTCs read and diagnose the issueThe ABS light is on because the ABS module detects something is wrong with the system. It will remain on until it is fixed. As long as the light ...
Can you mix P225 75R15 on one Axel and P235 75R15 on the other on a 93 Jeep Grand Cherokee with part time 4 wheel drive?
There shouldn't be an issue with it when the two fatter tires are on the rear and thinner on the front, but don't mix them up left to right. We used to do this a lot when driving on sand, we put fatter tires on the front for flotation and better steering.Not if the vehicle is 4 wheel drive.
parking break is on or low break fluid
If the four wheel drive shifter only has four high, neutral, and four low it is full time. If it has a two wheel, position, it is part time.
I'm not 100% certain, but I believe that model year still uses a mechanical speedometer, in which case, it's likely either your speedometer cable or faulty gears in the speedometer itself.If it is electronic - which is possible, as again I'm not 100% certain that the 95 uses a mechanical speedome...
i have heard a vehicle speed sensor can cause it but not sure
There is no way to tell on the steering column, I'm assuming your wondering why the ignition key doesn't match the door lock key, in that instance there is no way to tell, the car could have been re keyed on either for a multitude of reasons. On the other hand if your curious to see if the doors ...
It would depend on the trim level. The label in the driver side door jamb should list what size it was built with.
The obvious answer is the one the Jeep sells at its dealerships parts department.
Around 60-70 lbs cold, 35-40 lbs at normal operating temperture, and 15-30 lbs warm at idle.
The fuel tank holds 24.6 US gallons. You do the math.
Most auto parts stores can supply you a re-manufactured engine with a decent warranty for your Cherokee. If you want "new" you will have to do business with a Jeep dealership and pay through the nose.
The engine computer is the voltage regulator in a 1997 Jeep Grand Cherokee.
Bad shock absorber.Bad/worn shock absorber bushings. Broken exhaust pipe/hanger.Bad/worn sway bar links or bushings.
Jeep Grand Cherokee WJ - Spark plugs.Both the 4.0L 6–cylinder and the 4.7L V-8 engine use resistor type spark plugs.4.7L V-8 engines are equipped with “fired in suppressor seal” type spark plugs using a copper core ground electrode.
Six quarts of conventional oil with filter at my dealer is under $40.00.
Pinched or blocked transmission cooling lines
Residual vacuum from vacuum reservoir.
Combined (City/Highway) MPG, 16
yea they both have the northstar engine.
2000 jeep grand Cherokee all four of your windows don't work you don't believe it is a fuse any ideas?
yes !!i would check the fuse yes !!i would check the fuse
At the front left corner of the fuel tank. You'll need to jack up the rear of the car to reach it.
What can cause my windshield water to fail on my 2008 Jeep Cherokee The pump sounds like it is still trying to pump water.?
Spray nozzles can also be clogged with wax. Clean them with a needle.First check the reservoir to be sure it's not empty then inspect the hoses.
It depends greatly on what transmission.The aw4 uses dextron 3, a 42re or 44re uses Mopar ATF+4.A manual uses 75w90. The new Cherokee with the nine speed transmission uses a special dealer only fluid.
take off door panel remove door lock componets and go from there
The "Check Gauges" light means just that.Look at all the gauges while engine is running and see which one is not in it's normal range.I suspect it is the oil pressure gauge is trying to tell you something, especially if you say there is a rattle when you drive (engine clatter).
You would like to know reasons a heater core could go bad or be damaged say in an accident On a Jeep Cherokee Limited 1995.?
without knowing the extent of the damage I can only say that any impact causing damage to any of the hoses, fittings or in the area of the heater core can make it leak or prevent coolant from flowing through it.
If the part number is the same and the configuration is the same then sure.
depends on driving conditionshigh heat 10w40cold 10w30/ SAE 30
The check engine light would be illuminated and TPS related codes would be confirmed and/or pending.
The fuel pump relay is grounded through the ECM.
Ok, so I found that the fuel pump FUSE is the ECM BATT fuse which is #9 in the fuse box on the driver side (accessible when driver door is open).The fuel pump RELAY is in the glove box (there are 3) and it is the one on the left,closest to the driver side.
under the hood, right side, color brown, 15 pins, under to another relay grey
If it's fuel injected the fuel pump is located inside the fuel tank.
The fuel pump is located inside the gas tank.
It will be warmer than the standard/specified 195F thermostat. I've owned mine for 230,000 miles, and it's consistently just below the 210F mark on the gauge in the winter, and just touching the low side of that mark in the summer. I trust Brian Mette's information.200-220 deg F
A sensor, no. If that is a feature on a 1996, it is a function of the power door lock system.
It does not have a fuel pump cutoff switch.
The fuel pump relay is silver in color and located right above the fuse box panel under the driver's side dash. Go under the driver's side dash and stick your hand up there and feel the parts, there are two of them and it should be the top one.
There isn't one. That's a Ford thing.
Mounted on top and inside the fuel tank.
In the relay box with the other relays.
No You Will Not Be Able To Do This. The Relay Is Required To Make Your Electrical System Work For The Fuel Pump. The Relay Is A Switch Unto Its Self. It Shuts The On And Off As Required By The Fuel System. Even If You Were To Bypass It. The Pump Would Run All The Time. Suggest You Install A New R...