what?are you asking not sure what ya want to know?
there is a transmission cooler inside your radiator and it must be leaking. probably replace the whole assembly
Look in a removable housing at the engine end of the upper radiator hose
Driver's side in front of the engine near the ground. See that canister in front of the engine with the screw top? That's it.
After looking at the ( 1996 , 1999 , and 2002 ) Mercury Villager Owner Guides :The fuel tank capacity is ( 20.0 U.S. gallons / 75.7 liters )
To adjust the presets on the radio hold down the preset buttons when the selected radio station is on. This will select the chosen radio station as a preset option.
It is important to know the location of the fuses and relays within a car. The fuel pump relay for this car, is found in the fuse box under the hood.Ê
There is no way to tell what tht art is based on the part number you gave. It is only a partial part number. That is the prefix and suffix, which only says what kind of car it fits and other stuff like if it's left hand or right hand, stuff like that. The base part number, which is a 5 or 6 digit...
dirt and gunk in linkages will cause accelerator to stick get some wd40 and spray on all moving parts if accelerator has a cable, renew cable as it will be clogged and rusted inside casing, making it stick
If brake lights remain on - check the operation and adjustment of the stoplight switch usually located at the upper end of the brake pedalMy lights remained on all day, draining my battery. I found a shim on the upper brake pedal linkage between the linkage and the light switch. The shim had rott...
It may well be the timing belt causing the problem. The belt can still be "on' the pulleys and be defective. The underside of the belt has teeth on it that are used to turn the camshaft that operates the valves for the engine. This belt is under tremendous strain when it's working and they DO wea...
It's doable, but not really feasible. Especially for a car as old as that and which doesn't have any particular collector's value. You'd be sinking a lot more money into it than it's worth.
Bad MAP sensor, throttle position sensor, O2 sensor, many possibility's it would be a good idea to get it down to a repair shop for an exact diagnosis.
The 1989 Mercury Tracer 1.6 liter engine cylinder head bolt torque specification is 135 pounds. The cylinder head bolts should be torqued in 45 pound intervals.
You have to remove the drive axle to replace the seal- you have to first remove the tire, then the brakes/caliper/rotor, large center axle nut, unbolt the tie rod end, unbolt lower ball joint, push end of axle through hub while pulling hub outward till you can shift the axle out of the hub. Then,...
Remove wheel Re-install 2 lug nuts to hold rotor in place Remove caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully retract piston into caliper body Replace inner and out pads Re-install caliper PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
If your 1997 Mercury Tracer has a battery light that blinks on and off while the car is running, it most likely means that the battery is not charging. This could be an issue with your alternator.
You can view the 1998 Mercury Tracer owners manual online at :www . motorcraft service . com ( no spaces )Click on Owner Guides( the fuses and relays section starts on page 104 , it has the diagrams and lists )