FIRST CHECK YOUR WIRING TO FROM THE PUMP TO THE CLIP PART FOR A GOOD CONNECTION THEN CHECK FOR CORROSION LAST CHECK YOUR FUSES AND UP GRADE 10 AMPS IF YOU NEED TO.
yes, if the relay were stuck, or the contacts welded shut, it would allow the incoming Hot wire to pass power through to the other two wires.
Why the hell would you want to?
In the trunk of the vehicle is a switch that says on/off ANYTIME you raise your car even to change the tire make sure you turn it OFF. Sounds like you were unaware of this so you should shut it off now. In the future or if you still have the problem a good trick to do if your air bags are still i...
the modulator controls when it shifts.. the governor also controls this, but I'd flush the tranny and change the filter and fluid .... A good flush for an automatic is liquid Berrymans B-12... add it, go around the block slowly..then drain the thing and change the filter and fluid... when refilli...
Probably the knock sensor, look it up
If you are pulling a trailer you should use the D instead of the OD this will give you more power to the wheels. As for the other lower gears they would come in handy say if you lost your brakes and needed to decelerate other than that you should just put it in OD
take vin number to ford dealer and they should give them to you
Cycle the key on/off 8 times and the door locks will lock and then unlock. Press the lock button on your key fob to program it
They came with 16 or 17" in 6(steels) 6.5 or 7 inch widths (aluminum rims) aluminums have 12mm offset. If they are factory rims the driver's door/jam sticker will give diameter and width, on the back of the rim spoke will also give this info and part#. If you want to measure it yourself diameter ...
Below is a link to a complete conversion kit. The cost is around $1,000. http://www.performancesuspension.com/MOPARbrakes.htm
That is a wide open question. I take it someone told you this was the code stored in your car's computer and your MIL or Check Engine light is on. This code means that, for some reason, the vent solenoid (located under the car near or on the emissions canister) is not working when it should. It c...
Disconnecting the battery is usually sufficent. The fuse they are tlkng about (probably) is a memory fuse but the battery disconnected after a bit will wipe all that out. The memory fuse is used for holding clock settings, and radio station settings. Stuff like that. Hope this helps.
No. The owner must sign the certificate of title in order to make the transfer.
Wire the fog lights directly to a power source or the battery through a separate switch. You can then turn them on at any time. This may be illegal in your state, so check to be sure.
Could be,a blown fuse,burned out bulbs,bad brake light switch,or an improperly installed brake light switch.
its located under the dash on the brake pedal has a clip holding it in place and a connecter that goes to it really easy to replace just look under the dash
The system must be evacuated first using a vacuum pump. then freon can be added to the low pressure side.
your door is not closed tight enough or the switch is possably broke. check the manual switch by the headlight swich, it maybe turned on. some reason your not opening the circut when the door is closing.check the position of the dome light control switch you probably turned it on inadvertently ju...
Many vehicles use engine vacuum to operate the HVAC functions. If the vacuum supply is cut off for whatever reason the HVAC system defaults to the defrost mode only. Look for a disconnected, cracked or pinched HVAC vacuum supply line under the hood.Also, if the vehicle has a cabin filter that is ...
It would depend on how you drive it and if you force it to slip. The more it slips the quicker it will wear out.Maybe a year or more, maybe a day. Lots of factors go into it... how badly the clutch is deteriorated, how well you use the clutch, how much weight and resistance is going against that ...
I would have to say definitely not. Your 88 has either the 302, 351 or a big block. The 98 explorer probably has some teenie 2 liter something or other. I am not 100% sure though so hopefully someone that is will come along for ya.
YES (with the owner's permission)
u will probably need to remove the door card and gain access behind the door handle to remove the lock.Glad to be at assistance
Hello, Jamison here. It can be done, BUT, Its nearly impossible, EVEN FOR A MECHANIC. I have to disagree. I've done it many times for folks who cannot afford a complete repair. Usually, the reguator,or the lifting mechanism has broken or become disconnected. A temporary quick fix I have done requ...
The powersteering reservoir has the filler tube molded on/in it.
Hello, Jamison here, Try to turn on the lights and A/C at the same time you will have the same effect,,,,,,,, You have A BAD ground someplace, I would start at the battery, Does it start on its own OK? Try this, Put JUST ONE WIRE of jumper cables on from battery ground to engine block, can also a...
Yes. Also consider catalyst internally broken and rattling. Please desribe quality of sound and conditions.If catalyst is bad, check for misfire and/or faulty distributor stator or excessive amount of engine oil.
You need a good tranny shop. There is something major wrong inside.
If the check engine light is blinking that means that an engine cylindermisfire has been detected . You can drive it in for repair , just avoid anyrapid acceleration or deceleration because you can damage the catalyticconverter
Well replacing wheel bearings on a ford lazer (87) is not the easiest of jobs compared to some other small cars,The front wheel bearing kit that you buy for a DIY job usually contains two cone shaped bearings (2 per side) , the housings that they go into , oil seals and a set of spacers ( 1 steel...
It depends upon the type of vehicle and the jurisdiction in which you registered the vehicle. Generally, motorcycles and trailers require only one license plate. In North America, all passenger vehicles have at least one license plate affixed to the rear of the vehicle, and in some jurisdictions,...
HI IF THERE IS A HOLE FOR THE BARREL ITS A MANUALLY LOCKIN DOOR IF THERES NO HOLE ITS A CENTRAL LOCKING OPERATED DOOR SO YOU WOULD PROB HAVE TO PUT ALL YOUR WIRING/LOCK MECHANISM IN IT..................
Later Austin Healy Sprites, and MG midgets had front discs and almost identical front suspension. If you have the front spindles rebushed to the Metro dimensions and use the bolt-on wheel hubs (not knock-offs) you can install the front disc brakes. It took me a while to round up the parts from va...
Depends on your exact MPG, but I have a 1993, My fuel reader doesn't work perfectly, but it's roughly 220-240 miles per full tank, city only, maybe more (or less) highway
on the side of the shifter there is a od button
Car seat installation is different for every vehicle. To make sure this is done 100% correctly call your local non-emergency police phone number and tell them you need car seat installation. They will schedule an appointment with you for free and walk you through the installation step - by - step...
It is a vent for the rear diff. Attach it high up anywhere so water can't get into it.
Needs a tune up? Bad EGR valve maybe? Vacuume leak? Hard to say.
You cannot deactivate the seat belt alarm. It is installed to keep all riders in the vehicle safe.
Find and remove or disconnect the chime relay.
The temperature at 80 F has nothing to do with it. Whatever broke it, the weather is not to blame.
The shop manual for the car( dealer item ) should have it ...you could check eBay to see if there is one available ...or purchase from the dealer some cars have it under the hood just look around xxxxxxxxxxxxxxx ANSWER xxxxxxxxxxxxxxxxxxx Purchase a Haynes Manual that is specific to your car at a...
put the red coded key in the ignition turn it to position 2 quickly 3 times listen for a beep once the beep has sounded leave it in the ignition press one of the buttons on the key in the ignition the the same button on the new key fob that will program the new fob signals to the origanl.
Check to see if you are getting power to the motor - if so motor is bad If not could be a bad switch or broken or disconnected wire
no they wont the safest place for a child is in the rear seat until they are 4 ft 2 in tall
A 4.0 ford ranger will hold 10 quarts of transmission oil. This is if the if the transmission is totally dry including the lines and the transfer case.
Try J.C. Whitney.com they used to have a unit that connected to the window crank handle
The year, engine size and if it is the intake manifold or an exhaust manifold gaskets would help.
Unless you are towing something or encountering steep hills (do you live in San Fran?), you should always be in overdrive. The lock-up into overdrive won't occur unless you are going fast enough, anyway, so there is no reason not to keep the gear selector in OD.
The best way it to take your Ford Explorer to the nearest Ford Dealer. He will doubtless employ mechanics who will be glad to replace the headlight assembly.
When making any changes to a vehicle, a diagram can help point the person in the right direction. A vacuum line diagram for a 1988 Plymouth Horizon can be found in its maintenance manual.
In Mississippi the plates remain with the car. You need to call the bank. They will give them to you most likely.File a stolen report and sue the lender in court.They do not have a right to your plates nor your personal propery.SUE THE BANK/LENDER NOT THE REPO MORON !!!You should Report The Plate...
Later model Rangers are real bad about the PCV hoses melting and causing air leaks. Check all the PCV hoses and elbows and anything else that might be in that system.
You can purchase an adapter (OTC 6604) and fluid pump (Plews 55001) from Amazon that gives you the necessary tools to fill or top off the automatic transmission fluid on that Explorer. It's really quite easy and would be considerly cheaper than trying to add a dipstick. Vehicle needs to be lifted...
Be more specific, Are you talking about the transfer case, transmission, or front differential?
I had this problem once with my 2000 Malibu, It was a resistor that I needed to replace. I received instructions from some guys off the internet and fixed it myself. I don't remember the name of the site. Where are all the guys out there to answer these questions? signed a (blank) blonde.
right side rear flap in trunk...or call a dealerships shop foreman or... the library should have a shop manual for this vehicle, you can make copies of the right sections :)
The powertrain control module on 1991 and 1992 Ford Explorer is in the right front passenger area behind the right front kick panel
Standing in front with the hood open, just to the right of the air filter box . Will have wires going to it. ( 4.o engine)
have your front driver side control arm bushings checked and ball joint and tie rod end well have them check both sides just in case
Did you hear about the tight end who went to prison? He came out a wide receiver
There is an easy fix kit called the "HeaterTreater" that is available on eBay and at heatertreater.net. This fix is all-inclusive, easy to install, and only takes about 45 minutes. It cover Ford Explorers and Rangers from 96'-04'
You need to go under the car behind the grill with a long screwdriver and pop it manually.
If you have an Auto Zone or Advance Auto in your area they sometimes sale manuals for older model vehicles. If they do not have one for your 1992 they should still be able to assist you with the fuse box layout. You can also find one online at www.repairmanual.com. I would still recommend checkin...
Don't know what a 1992 Mitsubishi tr efi magna is so Look HereGood Luck and Remember.Change Your Mind, Not Your Oil.Use the First In Synthetic Motor Oil's.See My Bio For more information.
flasher relay history flasher relay history
Try the dealer, if they are of no help, try this site: www.rangerpowersports.com
In most cases. Manual transmissions have superior mileage because putting an automatic tranny in a car makes it heavier. Also, manuals are more reliable and do not break down as much if driven correctly. The superior in fuel economy and acceleration factors with the RPM. In a manual you choose th...
After learning that our Ford dealer would charge us $40 to tell us the factory unlock code, I looked on the computer module. The code sticker is NOT on the front of the module. However, I was able to locate it on the back. Here's how:Remove the three hex head screws under the front edge of the pa...
Not sure about other states, but in Georgia when you buy a tag for your vehicle that is YOUR tag, if you sell your car or it gets repo'd you can get the tag and trasfer it to another vehicle.
fuse panel is on rhs footwell near the accellerator on rhd models
Hello, I have a 1990 Cutlass Supreme, I recently bought it from my best friend, and it was doing the same exact thing. It turned out to be that the fuel injectors were clogged. My mechanic had to take allot under the hood apart in order to get to some of them, so I would have this checked last if...
The oxygen sensor reports live information about the engine's air/fuel mixture to the powertrain control module, (Computer). This information is used primarily to help calculate fuel delivery to the engine, which changes continuously while it is running. If the engine is running lean, the powertr...
You fill a tranny through the dipstick tube. You will need to buy a small funnel.
Brake jobs are not a job to be done without a Manual. Your life and the lives of others and the life of your Automobile depend on them. [http://www.themotorbookstore.com/index.html Please purchase a Manual and do the job correctly].
slipping alternator/power steering/ auxillary drive belt
Any contact will probably cause some minimal damage.