Where can you buy ground effects for an 89 Berretta or is there another type of car you can use them off of?

By "ground effects", are you referring to aftermarket neon/LED/cathode lights that are mounted to the underside of the vehicle, or do you mean body kit and side skirt pieces?The lights are available at most department or automotive stores, or through several online sources. Just search.Body kits ...

Read more

What is the 1994 Chevrolet beretta 3.1 coil pack firing order?

The firing order for the 1994 Chevrolet Beretta is 1, 2, 3, 4, 5, 6. This is for the 3.1 Liter engine.

Read more

Can you fit some Toyota MR2 2004 wheels onto your Toyota MR2 2000 car?

Yes, the mr2 mk3 wheels fit all years 2000 to 2007. They will not fit the mk2 model which has a 4 stud pattern rather than the mk3 5 stud pattern.

Read more

1989 Chevy berreta car stays running after key is off and pulled out?

Try a new starter or ignition.

Read more

Your 94 v6 beretta locks up the the left rear brake when driving slowly sometimes feels like it sticks while you are driving and drags the car down?

My beretta does the same thing only it is a 1994 and not running right now, I need to figure out how to bleed the clutch to get pressure. But when your brakes lock up on the back it is something to do with how much pressure the brakes are putting on they either are not putting enough pressure or ...

Read more

Why is your gear control moving freely from park to drive on your 1990 Chevy Beretta?

I would believe the spring loaded detent has broken. Obtain a complete shifter from a salvage yard ( about $35.) and replace yours or rob the parts you need off it. Good luck.

Read more

The fuel pressure that is required'?

depending on the model 4cyl. 2.2 and v6 2.8 and 3.1 have 35 to 40 psi running and 40 to 45 psi initial key on engine off--- as for 2.3 ltr quad 4's 40 to 45 pi running and almost 50 to 55 psi key on engine off

Read more

What would cause a 2004 Ford Taurus to stall every 2 minutes exactly while in park but start up and drive good?

reset your pcm by pulling either the main relay or negative terminal off battery, if still happens then you need to take to ford to get them either one of the 2 ,1 get timing set,or 2 get your computer updated.

Read more

What causes a 1989 Chevy beretta 2.8L to stall as soon as engine gets warm and wont restart til car cools?

sounds like you have a problem with the ignition if if has coil packs it will do that or it could be the wires but problay the ignition is wore out . it might not look bad but the inside is gone once you put any kind of stress on it

Read more

Where is the temperature sending unit for a 95 Chevy beretta?

The temperature sending unit for a 1995 Chevy Beretta is on the front of the engine. It is between the front of the engine and the radiator inlet/outlet.

Read more

1992 Chevy beretta turn signals are not workingand have changed flasher unit?

Sounds like a bad ground somewhere..steve

Read more

1989 beretta the motor gets hot after driving it for about 30 minutes. I put the car in Neutral and it will cool down as you coast Then you can put it back in drive and go for 10 minutes then hotagain?

Low on antifreeze/antifreeze leak...loosenut...www.ceriousproductions.com

Read more

What could cause a 1994 Chevy Beretta to over heat?

You should check your thermostat and maybe your water pump,catalitc converter, heater core, hoses might have holes in them or maybe low and colant

Read more

91 Beretta starts but runs rough and is backfiring and blowing black smoke when able to get it to stay going running not so rough the car would stall and if i held the gas on was overheated by home?

sounds like coolant temp sensor is bad but also sounds like cat might be pluged

Read more

Where is the vehicle speed sensor located on a 1994 Pontiac Sunbird 3.1L?

In the 1994 2.0L engine sunbirds, the VSS is located above the passenger's side drive axle, I would imagine the location is the same for a 3.1.

Read more

How many tons are in a 94 Chevy beretta?

Assuming you're referring to weight, it's around 1 1/2 tons

Read more

There was a popping sound under the car and now it runs ragged and has a gas smell.?

the plug popped out of the cat converted, you need a new one.

Read more

How does a desk fan works?

A mechanical fan is an electrically powered device used to produce an airflow for the purpose of creature comfort (particularly in the heat), ventilation, exhaust, or any other gaseous transport.Mechanically, a fan can be any revolving vane or vanes used for producing currents of air. Fans produc...

Read more

What type of oil and weight for a1996 Chevy beretta?

Should be listed on the oil cap and in your owner's manual. I think you will find it is 5w30.

Read more

Speedo doesnt work on 1995 beretta where is speed sensor?

there are 2 ,the ones on the front brakes if you have ABS and the one inside the transmission that usually gives the speedometer the drive indication.

Read more

What is the gas mileage for a 91 beretta?

well i don't know about a '91. i have a '94 3.1 v6. and i get around 16-18 in town and around 20-22 on highway. so i would assume you get around the same as me. I have a 91 3.1 and i get about 18 in the city and 24 highyway ------------------------------- Engine Size (liters) 2.2Cylinders 4MPG (c...

Read more